[DeTomaso] I need some help with parts!
Mark McWhinney
msm at portata.com
Thu May 10 22:38:43 EDT 2007
Check this months POCA newsletter for the Jack Stand article about a bolt-up
swap with SSBC's vented rotors.
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of mikeldrew at aol.com
Sent: Thursday, May 10, 2007 7:17 PM
To: forestg at worldnet.att.net; detomaso at realbig.com
Cc: jontpr at comcast.net
Subject: Re: [DeTomaso] I need some help with parts!
Forest wrote:
As I recall Parapantera in Portland says that 67 Mustang hub/rotor
assemblies are a direct replacement. The wheel studs would be American
thread though.
>>>If I recall correctly, even though the bearing sizes are the same,
the rotor is a smaller diameter, which means that part of the pad hangs
out over the top of the rotors. That doesn´t make it ´right´in my
opinion.
Somebody tell me if I´m wrong about this?
Mike
________________________________________________________________________
AOL now offers free email to everyone. Find out more about what's free
from AOL at AOL.com.
=0
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list