[DeTomaso] Engine Oil Analysis / Willow Springs Update
Dan Courtney
dfcex at pacbell.net
Wed Mar 14 16:04:41 EDT 2007
> Donny,
> The oil analysis showed above average metals from probably bearing, ring
> and cylinder. It's definaltly coming out.
>
> Dan
> Dan F. Courtney
>
>
> Excalibur Commercial Real Estate Services
> La Jolla, CA
>
> Phone (858) 551-5455
> Fax (858) 551-5456
>
> ----- Original Message -----
> From: "Donny Williams" <donnylee at ccwebster.net>
> To: "Dan Courtney" <dfcex at pacbell.net>
> Sent: Monday, March 12, 2007 3:09 PM
> Subject: Re: [DeTomaso] Engine Oil Analysis / Willow Springs Update
>
>
>> Dan sounds like a block Brace... I have not seen one of these rascals in
>> the lifter valley first hand. I run a stud girdle up top, and nothing in
>> my valley for a block brace. Can you take a picture of it with your cell
>> phone and shoot it to me? A Block brace should just be bolted into the
>> block in the valley area. I am not familiar with the springs your seeing
>> down around your lifters either.... There should be no springs on your
>> lifters only your Valve springs on top of the head. I need to see what
>> your looking at.
>>
>> You should just see dog bone brackets tying two lifters together with
>> this block brace over the top you mention. Personally I think we are
>> looking at the bronze particles from the dizzy gear in your filter. And
>> at least that is good so far! If it was real bad you would know!
>>
>> ----- Original Message -----
>> From: "Dan Courtney" <dfcex at pacbell.net>
>> To: "Donny Williams" <donnylee at ccwebster.net>
>> Cc: "Taphorn, John (KINGWOOD, TX)" <John_Taphorn at ml.com>
>> Sent: Monday, March 12, 2007 1:06 PM
>> Subject: Re: [DeTomaso] Engine Oil Analysis / Willow Springs Update
>>
>>
>>> Donny, no visible particals beyond gold dust. It's a K&N filter and the
>>> only big stuff is gasket flakes.
>>> I looked at the roller lifters again. There is a 1/4" gold plate on top,
>>> part of the Jomar stud girdle I assume, and the lifters are help in
>>> place by having to fit inside this plate. It looks like the lifter
>>> springs have to be compressed some how to get them out.
>>>
>>> Dan
>>>
More information about the DeTomaso
mailing list