[DeTomaso] Torque Spec

[Jeff Kimball]

Bud:

I didn't see where anyone answered your question, so here goes a shot at it.  It should be close.

A cursory review of Pantera data produced similar results, no torque specified.

I did find a reference in a Chilton's manual installing a C6 (aluminum case) to a Ford block.  It's not specific which block, but the 351C is in the range covered by the manual.  It specifies 50 Foot Pounds.

I suspect this is "Close enough for Government work"..  Hopefully someone will have access to some real Ford data and can verify this.

Good luck.

Jeff/#2467


> On 08/02/2021 12:30 PM B Hower via DeTomaso <detomaso at server.detomasolist.com> wrote:
> 
>  
> To All,
> 
> I am in need of Torque Spec for bell-housing to block and ZF to bell-housing, I can't seem to find my past formation.
> 
> I would be thankful for any information of same...
> 
> Bud #3400 ( Drive it like there is no tomorrow -- for there may not be ! )
>    To All,
>    I am in need of Torque Spec for bell-housing to block and ZF to
>    bell-housing, I can't seem to find my past formation.
>    I would be thankful for any information of same...
>    Bud #3400 ( Drive it like there is no tomorrow -- for there may not be
>    ! )
> _______________________________________________
> 
> 
> Detomaso Email List is not managed by POCA
> Posted emails must not exceed 1.5 Megabytes
> DeTomaso mailing list
> DeTomaso at server.detomasolist.com
> http://server.detomasolist.com/mailman/listinfo/detomaso
> 
> To manage your subscription (change email address, unsubscribe, etc.) use the links above.
> 
> Members who post to this list grant license to the list to forward any message posted here to all past, current, or future members of the list. They also grant the list owner permission to maintain an archive or approve the archiving of list messages.