[DeTomaso] Speaking of EFI--Water Temp Sensor Question

Thomas Törnblom tipo874 at gmail.com
Tue Jul 28 12:01:37 EDT 2020


I’m using the bung in the pipe from the thermostat to the swirl tank, where the vacuum thermo-switch was located.

I have drilled a couple of small holes in the thermostat so there is some flow there even when the thermostat is closed.

Thomas

> 28 juli 2020 kl. 17:53 skrev Richard Greenblum <richard at richardgreenblum.com>:
> 
> All,
> 
> Where did you locate the water temp sensor for the EFI system?  With no water in the intake, 351C’s are short one location.  I’m very reluctant to drill into the front of one of the heads (CHI 4V).  I understand teeing off the current water temp sensor for the gauge will not yield accurate water temps.
> 
> Thanks,
> 
> Richard
> Austin, TX 
> 
> _______________________________________________
> 
> 
> Detomaso Email List is not managed by POCA
> Posted emails must not exceed 1.5 Megabytes
> DeTomaso mailing list
> DeTomaso at server.detomasolist.com
> http://server.detomasolist.com/mailman/listinfo/detomaso
> 
> To manage your subscription (change email address, unsubscribe, etc.) use the links above.
> 
> Members who post to this list grant license to the list to forward any message posted here to all past, current, or future members of the list. They also grant the list owner permission to maintain an archive or approve the archiving of list messages.


More information about the DeTomaso mailing list