[DeTomaso] Best jacking points for floor jack?

[Mike Drew]

Julian,

Yes, that’s right. When in doubt, read the manual. :)

I also jack from the rear crossmember, protecting the sheetmetal lip by putting a 2x4 on top of the jack pad which indexes on the frame rail. 

Mike

Sent from my iPad

> On Aug 18, 2020, at 19:24, Julian Kift <julian_kift at hotmail.com> wrote:
> 
>    I thought the holes in the chassis rails (just behind the front wheel
>   fender well and at the rear just in front of where the chassis rails
>   angle toward the engine mounts) were there as a keyway for the stock
>   scissor jack to sit in?
> 
>   Julian
>     __________________________________________________________________
> 
>   From: DeTomaso <detomaso-bounces at server.detomasolist.com> on behalf of
>   Ken Green via DeTomaso <detomaso at server.detomasolist.com>
>   Sent: Tuesday, August 18, 2020 6:21 PM
>   To: DeTomaso Mail List <detomaso at server.detomasolist.com>
>   Subject: [DeTomaso] Best jacking points for floor jack?
> 
>   Anyone have a chart?
>   Thanks
> _______________________________________________
> 
> 
> Detomaso Email List is not managed by POCA
> Posted emails must not exceed 1.5 Megabytes
> DeTomaso mailing list
> DeTomaso at server.detomasolist.com
> http://server.detomasolist.com/mailman/listinfo/detomaso
> 
> To manage your subscription (change email address, unsubscribe, etc.) use the links above.
> 
> Members who post to this list grant license to the list to forward any message posted here to all past, current, or future members of the list. They also grant the list owner permission to maintain an archive or approve the archiving of list messages.