[DeTomaso] Deck Lid Release
FAITH MCCALL
rfmccall at comcast.net
Tue Dec 18 08:29:22 EST 2018
Mike,
When I bought 1086 a few years ago, the door jamb release cable was long gone and someone had welded a small steel rod to the part of the receiver where the cable would normally attach . It went straight down and had a 90 deg bend so that it exited a tiny slot cut into the AC grill directly below the license plate. It offered very east access to the release and was not noticeable unless you knew that it was there .I thought it was a pretty logical, simple modification.
Also, this latch mechanism is used on a LOT of cars! Lamborghini, Ferrari, Alfa etc....
Ron
-------------- next part --------------
Mike,
When I bought 1086 a few years ago, the door jamb release cable was
long gone and someone had welded a small steel rod to the part of the
receiver where the cable would normally attach . It went straight down
and had a 90 deg bend so that it exited a tiny slot cut into the AC
grill directly below the license plate. It offered very east access to
the release and was not noticeable unless you knew that it was there .I
thought it was a pretty logical, simple modification.
Also, this latch mechanism is used on a LOT of cars! Lamborghini,
Ferrari, Alfa etc....
Ron
More information about the DeTomaso
mailing list