[DeTomaso] A-arm bushings...should they require machining?
Joseph F. Byrd, Jr.
byrdjf at embarqmail.com
Thu Sep 21 18:32:11 EDT 2017
I have removed the bushings from the front A-Arms and have found their ODs
to be a consistent 1.184". the A-arm bore IDs varied slightly around
1.181". this makes sense as the IDs would be 30mm with the bushings
oversized for MY expected press fit of ~ 0.003".
NOW, the new bushing ODs vary around 1.189". to ME, that is way too much
press and could plastic yield the A-arm bores.
Is it expected to machine the new bushing ODs? (Pretty common practice for
new parts to be oversized for field fitting in the machines I use to work
to allow for possible damage/wear.)
OR
Throw away the micrometers and get a bigger press?
Joe/5177
-------------- next part --------------
I have removed the bushings from the front A-Arms and have found their
ODs to be a consistent 1.184". the A-arm bore IDs varied slightly
around 1.181". this makes sense as the IDs would be 30mm with the
bushings oversized for MY expected press fit of ~ 0.003".
NOW, the new bushing ODs vary around 1.189". to ME, that is way too
much press and could plastic yield the A-arm bores.
Is it expected to machine the new bushing ODs? (Pretty common practice
for new parts to be oversized for field fitting in the machines I use
to work to allow for possible damage/wear.)
OR
Throw away the micrometers and get a bigger press?
Joe/5177
More information about the DeTomaso
mailing list