[DeTomaso] Adjusting front hood latch

[Jim Kosloskey]

All,

Thanks for all the help.

This is a case of PUE (Probable User Error). :-0

I just needed to be more forceful while pressing down on the hood at the
latch position.

The suggestion to use a screw driver to understand the mechanism allowed me
to opine more force was needed.

-----Original Message-----
From: The DeTomaso Registry Guy [mailto:detomasoregistry at gmail.com] 
Sent: Monday, September 11, 2017 5:31 PM
To: 'Jim Kosloskey' <jim.kosloskey at jim-kosloskey.com>;
detomaso at server.detomasolist.com
Subject: RE: [DeTomaso] Adjusting front hood latch

Jim,

I am looking at your photo now...  Not sure exactly about your symptoms.

It has been decades since I had to futz or fettle with my hood latch.  
I'll have to go later and review my latch, to understand how it works
(again).

But I think the front fork (with the spring attached) is what pops up the
hood when you pull the release lever.  
So when closed this should be below the hood pin.

What I remember from my latch introduction, was that the forks, if not well
lubricated, would keep the components from going completely down, until you
hear the click.

Thumb it back all the way and check.  Does it work if you manually position
the fork(s)?

Adding a new trunk gasket can cause fitment issues also.


How should one close (latch) a hood ?
It scares me to see someone (rarely an owner) DROP a hood (even part way
down) in order to close the hood... I >set< the hood down gently, then with
the palm of my hand right above the latch, I apply/press down brief and
quick to hear the 'click'.  
If it does not click easily, I thumb the rear fork back up and then repeat.

While the latch can be adjusted,
almost always a failure to latch is (lack of sufficient) lubricant related.

Chuck


All,

 

The front hood latch is not latching.

 

Almost looks like the latching mechanism needs adjusting but I do not know
how to adjust.

 

It appears the pin on the hood is actually catching the upper 'tine' of the
front 'fork' of the latch. Either that or the back 'fork' is not opening up
enough to allow the pin to slip behind it. Any way that is my take.

 

I have attached a picture of the latch in the open position. It just does
not seem right.

 

Was working fine last time I opened the front hood about a month ago.

 

Are there directions for adjusting this latching mechanism somewhere?

 

Thanks,

 

Jim Kosloskey

1974 Pantera L Yellow #6949