[DeTomaso] Techno question: stock wheel studs

[Larry Finch]

See attached photo.

Just as Joe’s drawing shows, there is a flat side to the stud shoulder.

Note it is facing the outside at all five locations. That is because it only fits in that position.

Note it is in a recessed area, surrounded by a circular ridge.

Should the bolt become loose, it will only rotate to where the flat edge transitions to the fully rounded stud shoulder,
at which point it will contact the circular ridge and cease rotating.

Larry




-------------- next part --------------
   See attached photo.

   Just as Joe's drawing shows, there is a flat side to the stud shoulder.

   Note it is facing the outside at all five locations. That is because it
   only fits in that position.

   Note it is in a recessed area, surrounded by a circular ridge.

   Should the bolt become loose, it will only rotate to where the flat
   edge transitions to the fully rounded stud shoulder,

   at which point it will contact the circular ridge and cease rotating.

   Larry

   [cid:93218C81-4BC6-4F5F-8BB3-22602A47685A at attlocal.net]
-------------- next part --------------
A non-text attachment was scrubbed...
Name: DSC00119.jpeg
Type: image/jpeg
Size: 368758 bytes
Desc: not available
URL: <http://server.detomasolist.com/pipermail/detomaso/attachments/20170529/88a32811/attachment.jpeg>