[DeTomaso] PORTERFIELD AP63 R4S Users: Info needed?!
Steve Liebenow
steven.liebenow at att.net
Fri Jun 30 17:11:12 EDT 2017
Hey!
Just received a new set of AP63 pads and was dinking around with the calpers checking some fitment....and found that the new pads are not drilled to accept the guide pin?!!? Without the pin, it would, to me, appear that the pad would be able to walk up/down...in/out about 1/4 inch, putting them off center of the pistons....which doesn't seem like a good way to operate a caliper.....
Can any Porterfield users comment? I have pinged Porterfield also...... Just trying to figure out if I need to toss these back in the mail.......
Always something.....then you find something else....!
Cheers! Have a great holiday weekend!!!
Steve
-------------- next part --------------
Hey!
Just received a new set of AP63 pads and was dinking around with the
calpers checking some fitment....and found that the new pads are not
drilled to accept the guide pin?!!? Without the pin, it would, to
me, appear that the pad would be able to walk up/down...in/out about
1/4 inch, putting them off center of the pistons....which doesn't seem
like a good way to operate a caliper.....
Can any Porterfield users comment? I have pinged Porterfield
also...... Just trying to figure out if I need to toss these back in
the mail.......
Always something.....then you find something else....!
Cheers! Have a great holiday weekend!!!
Steve
More information about the DeTomaso
mailing list