[DeTomaso] Spot weld cutter ???
Jeff Detrich
jjdetrich at gmail.com
Sun Jan 24 15:20:00 EST 2016
Blair
http://shop.blairequipment.com/Blair-Spotweld-Cutter-p/13224.htm
Drill pilot hole and then use this. Will not skip.
Jeff
6559
On Sun, Jan 24, 2016 at 12:55 PM, Larry Finch via DeTomaso <
detomaso at poca.com> wrote:
> All,
>
> Anyone have any specific recommendations for quality spot weld cutters?
>
> Appears there are different styles. Is one preferred over another?
>
> Eastwood auto body has several offerings. Wondering if they are any better
> than what is available on eBay or from other vendors?
>
> As all drill bits wear and become dull from being used, and these styles
> do not appear to be compatible with home sharpening, any rough estimates on
> how many spot welds can be successfully drilled out before a bit becomes
> too dull?
>
> Quality and performance, not price, is my primary concern.
>
> All advice greatly appreciated.
>
> Thanks,
>
> Larry
>
> Sent from me using a magic, handheld electronic gizmo.
> _______________________________________________
>
> Detomaso Forum Managed by POCA
> Posted emails must not exceed 1.5 Megabytes
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com
>
> To manage your subscription (change email address, unsubscribe, etc.) use
> the links above.
>
-------------- next part --------------
Blair
[1]http://shop.blairequipment.com/Blair-Spotweld-Cutter-p/13224.htm
Drill pilot hole and then use this. Will not skip.
Jeff
6559
On Sun, Jan 24, 2016 at 12:55 PM, Larry Finch via DeTomaso
<[2]detomaso at poca.com> wrote:
All,
Anyone have any specific recommendations for quality spot weld
cutters?
Appears there are different styles.A Is one preferred over another?
Eastwood auto body has several offerings. Wondering if they are any
better than what is available on eBay or from other vendors?
As all drill bits wear and become dull from being used, and these
styles do not appear to be compatible with home sharpening, any
rough estimates on how many spot welds can be successfully drilled
out before a bit becomes too dull?
Quality and performance, not price, is my primary concern.
All advice greatly appreciated.
Thanks,
Larry
Sent from me using a magic, handheld electronic gizmo.
_______________________________________________
Detomaso Forum Managed by POCA
Posted emails must not exceed 1.5 Megabytes
DeTomaso mailing list
[3]DeTomaso at poca.com
[4]http://poca.com/mailman/listinfo/detomaso_poca.com
To manage your subscription (change email address, unsubscribe,
etc.) use the links above.
References
1. http://shop.blairequipment.com/Blair-Spotweld-Cutter-p/13224.htm
2. mailto:detomaso at poca.com
3. mailto:DeTomaso at poca.com
4. http://poca.com/mailman/listinfo/detomaso_poca.com
More information about the DeTomaso
mailing list