[DeTomaso] Pantera Down! Need Help
cengles at cox.net
cengles at cox.net
Wed Jan 6 09:30:19 EST 2016
Dear Rob,
This is very simple, but I suspect the problem may be
the Pro Comp Distributor. If I am not mistaken, Pro Comp is a
superficial hipo Chinese company with an abysmal track record of crappy
parts and fragile quality.
Warmest regards, Chuck Engles
On Wed, Jan 6, 2016 at 7:25 AM, Rob Dumoulin wrote:
> Brad Freeman swapped out his Mallory Unilite and installed a Pro Comp
> Distributor and now his RPMs do not read correctly. For those of you
> who
> do not know Brad, his car is equipped with an electric clutch servo
> allowing him to drive the car with his paralyzed leg. Since the RPM
> readings are not correct, the servo unit not function properly and he
> cannot drive it.
>
> Here is the Setup:
>
> Pro Comp Low Profile Distributor
> Matching Coil
> No MSD 6AL and no Tach Adapter
>
> Here are the symptoms:
>
> Engine Runs Perfectly
> At idle, it shows 200 RPMs.
> Blip the gas and it jumps up appropriately then rests around 1,000
> where it
> should be for about 3 seconds, then drops back to 200 RPMs. The
> alternator
> was changed at the same time, if that is relevant.
>
> My MSD setup was years ago and I needed the 6AL and tach adapter to
> get
> mine working. Not sure how it is now though. I am going to visit him
> Saturday to help diagnose/fix it or swap his distributor back to the
> Mallory.
>
> Anybody have ideas as to what might be wrong or suggestions on how to
> best
> troubleshoot it?
>
>
> ------------------------------
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
> Posted emails must not exceed 1.5 Megabytes
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com
>
> To manage your subscription (change email address, unsubscribe, etc.)
> use the links above.
More information about the DeTomaso
mailing list