[DeTomaso] Metric Fasteners
Tomas Gunnarsson
guson at home.se
Wed Sep 30 04:03:01 EDT 2015
True. 0.8 pitch is standard M5 coarse thread. Typo by Jim perhaps?
Tomas
<-----Ursprungligt Meddelande----->
From: Forest Goodhart [forestg at att.net]
Sent: 29/9/2015 11:43:12 PM
To: detomaso at poca.com
Subject: Re: [DeTomaso] Metric Fasteners
This is an unusual thread pitch for M6 fasteners. They are normally
either 1.0 or .75 pitch. What are you going to use them for?Forest
From: J B Reardon via DeTomaso <detomaso at poca.com>
To: "detomaso at poca.com" <detomaso at poca.com>
Sent: Tuesday, September 29, 2015 9:57 AM
Subject: [DeTomaso] Metric Fasteners
I have been looking for some stainless metric studs, M6 .8 pitch
32mm
length.
Looked in all the usual places and can't get a match. Anyone know of
good sources for metrics? Do the international folks have sources?
Jim
-------------- next part --------------
True. 0.8 pitch is standard M5 coarse thread. Typo by Jim perhaps?
Tomas
<-----Ursprungligt Meddelande----->
From: Forest Goodhart [forestg at att.net]
Sent: 29/9/2015 11:43:12 PM
To: detomaso at poca.com
Subject: Re: [DeTomaso] Metric Fasteners
This is an unusual thread pitch for M6 fasteners. They are normally
either 1.0 or .75 pitch. What are you going to use them for?Forest
From: J B Reardon via DeTomaso <detomaso at poca.com>
To: "detomaso at poca.com" <detomaso at poca.com>
Sent: Tuesday, September 29, 2015 9:57 AM
Subject: [DeTomaso] Metric Fasteners
I have been looking for some stainless metric studs, M6 .8 pitch
32mm
length.
Looked in all the usual places and can't get a match. Anyone know
of
good sources for metrics? Do the international folks have sources?
Jim
More information about the DeTomaso
mailing list