[DeTomaso] Metric Fasteners

[Forest Goodhart]

This is an unusual thread pitch for M6 fasteners. They are normally either 1.0 or .75 pitch. What are you going to use them for?Forest
       

   From: J B Reardon via DeTomaso <detomaso at poca.com>
  To: "detomaso at poca.com" <detomaso at poca.com>
  Sent: Tuesday, September 29, 2015 9:57 AM
  Subject: [DeTomaso] Metric Fasteners
    I have been looking for some stainless metric studs, M6 .8 pitch 32mm
    length.
    Looked in all the usual places and can't get a match. Anyone know of
    good sources for metrics?  Do the international folks have sources?
    Jim

  
-------------- next part --------------
   This is an unusual thread pitch for M6 fasteners. They are normally
   either 1.0 or .75 pitch. What are you going to use them for?
   Forest
     __________________________________________________________________


      From: J B Reardon via DeTomaso <[1]detomaso at poca.com>
     To: "[2]detomaso at poca.com" <[3]detomaso at poca.com>
     Sent: Tuesday, September 29, 2015 9:57 AM
     Subject: [DeTomaso] Metric Fasteners
       I have been looking for some stainless metric studs, M6 .8 pitch
   32mm
       length.
       Looked in all the usual places and can't get a match. Anyone know
   of
       good sources for metrics?  Do the international folks have sources?
       Jim

References

   1. mailto:detomaso at poca.com
   2. mailto:detomaso at poca.com
   3. mailto:detomaso at poca.com