[DeTomaso] Detomaso Plate on Rear Cross Member

[Tom Shinrock]

The valve cover plate was already mounted on my car when I bought it, The PO attached it with two black countersunk screws located in the black area of plate,


Tom
5186



-----Original Message-----
From: Michael Shortt <michaelsavga at gmail.com>
To: detomaso <detomaso at poca.com>
Sent: Sun, Oct 4, 2015 8:58 pm
Subject: [DeTomaso] Detomaso Plate on Rear Cross Member


Good Evening,

   Which adhesive are most of you using to adhere the Detomaso
Valve Cover
   Emblem to the rear crossmember?

   I was thinking that JB
Weld might be overkill.

   Thanks,

   Michael Shortt

 
_______________________________________________

Detomaso Forum Managed by
POCA
Posted emails must not exceed 1.5 Megabytes
DeTomaso mailing
list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso_poca.com

To
manage your subscription (change email address, unsubscribe, etc.) use the links
above.

 
-------------- next part --------------
   The valve cover plate was already mounted on my car when I bought it,
   The PO attached it with two black countersunk screws located in the
   black area of plate,

   Tom

   5186
   -----Original Message-----
   From: Michael Shortt <michaelsavga at gmail.com>
   To: detomaso <detomaso at poca.com>
   Sent: Sun, Oct 4, 2015 8:58 pm
   Subject: [DeTomaso] Detomaso Plate on Rear Cross Member
Good Evening,

   Which adhesive are most of you using to adhere the Detomaso
Valve Cover
   Emblem to the rear crossmember?

   I was thinking that JB
Weld might be overkill.

   Thanks,

   Michael Shortt

_______________________________________________

Detomaso Forum Managed by
POCA
Posted emails must not exceed 1.5 Megabytes
DeTomaso mailing
list
[1]DeTomaso at poca.com
[2]http://poca.com/mailman/listinfo/detomaso_poca.com

To
manage your subscription (change email address, unsubscribe, etc.) use the links
above.

References

   1. mailto:DeTomaso at poca.com
   2. http://poca.com/mailman/listinfo/detomaso_poca.com