[DeTomaso] Muffler/Header Paint

[Jerry Knotts]

Tom,

The ceramic coatings are heat resistant for exhaust temperatures. Come 
in many colors now.  Goes on like powder coat and lasts better than any 
paint I have found.

jerry knotts


On 6/28/2015 4:41 PM, Tom Shinrock via DeTomaso wrote:
>     I finally got my car cleaned up from the rainy Houston trip (I couldn't
>     do anything for almost all of June due to getting pneumonia after I got
>     back) and noticed that I have very light surface rust on my GTS exhaust
>     and headers.  I painted both with heat resistant paint over 25 years
>     ago and the paint was getting pretty thin.
>
>     Before the rust takes over I want to clean up the surface and repaint.
>      Is there such a thing as heat resistant powder coat?  Also is it a
>     good thing or bad thing to replace the muffler bolts/nuts with
>     stainless hardware to eliminate future rust issues?
>
>     Thanks,
>
>     Tom
>
>     5186
>
>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
> Posted emails must not exceed 1.5 Megabytes
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com
>
> To manage your subscription (change email address, unsubscribe, etc.) use the links above.

-------------- next part --------------
   Tom,
   The ceramic coatings are heat resistant for exhaust temperatures.  Come
   in many colors now.  Goes on like powder coat and lasts better than any
   paint I have found.
   jerry knotts
   On 6/28/2015 4:41 PM, Tom Shinrock via DeTomaso wrote:

   I finally got my car cleaned up from the rainy Houston trip (I couldn't
   do anything for almost all of June due to getting pneumonia after I got
   back) and noticed that I have very light surface rust on my GTS exhaust
   and headers.  I painted both with heat resistant paint over 25 years
   ago and the paint was getting pretty thin.

   Before the rust takes over I want to clean up the surface and repaint.
    Is there such a thing as heat resistant powder coat?  Also is it a
   good thing or bad thing to replace the muffler bolts/nuts with
   stainless hardware to eliminate future rust issues?

   Thanks,

   Tom

   5186


_______________________________________________

Detomaso Forum Managed by POCA
Posted emails must not exceed 1.5 Megabytes
DeTomaso mailing list
[1]DeTomaso at poca.com
[2]http://poca.com/mailman/listinfo/detomaso_poca.com

To manage your subscription (change email address, unsubscribe, etc.) use the li
nks above.

References

   1. mailto:DeTomaso at poca.com
   2. http://poca.com/mailman/listinfo/detomaso_poca.com