[DeTomaso] '74 Taillight Lens
Tomas Gunnarsson
guson at home.se
Tue Dec 1 03:02:03 EST 2015
The original screws have a slightly undersize shank. You thread the
screw through the plastic by force and the screw once the threads are
past the hole spins freely in the lens when you tighten it.
Tomas
<-----Ursprungligt Meddelande----->
From: Mike Drew via DeTomaso [detomaso at poca.com]
Sent: 1/12/2015 5:55:59 AM
To: guido_detomaso at prodigy.net
Cc: detomaso at poca.com
Subject: Re: [DeTomaso] '74 Taillight Lens
> On Nov 30, 2015, at 7:54 PM, Guido deTomaso
<guido_detomaso at prodigy.net> wrote:
>
> "so when they are screwed into the lens they become a captured screw
> like the factory"
> Not sure how many have locked-on to this part of the discussion, the
> holes in the lenses are / should be smaller than the thread diameter
of
> the screws.
>
>>>...which should be impossible, no?
So how did they do it? Beats the heck out of me. I just spent five
minutes examining an old lens with its captured screws and can't figure
it out at all. It just makes no sense?
PFM....
Mike
_______________________________________________
Detomaso Forum Managed by POCA
Posted emails must not exceed 1.5 Megabytes
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso_poca.com
To manage your subscription (change email address, unsubscribe, etc.)
use the links above.
.
-------------- next part --------------
The original screws have a slightly undersize shank. You thread the
screw through the plastic by force and the screw once the threads
are past the hole spins freely in the lens when you tighten it.
Tomas
<-----Ursprungligt Meddelande----->
From: Mike Drew via DeTomaso [detomaso at poca.com]
Sent: 1/12/2015 5:55:59 AM
To: guido_detomaso at prodigy.net
Cc: detomaso at poca.com
Subject: Re: [DeTomaso] '74 Taillight Lens
> On Nov 30, 2015, at 7:54 PM, Guido deTomaso
<guido_detomaso at prodigy.net> wrote:
>
> "so when they are screwed into the lens they become a captured screw
> like the factory"
> Not sure how many have locked-on to this part of the discussion, the
> holes in the lenses are / should be smaller than the thread diameter
of
> the screws.
>
>>>...which should be impossible, no?
So how did they do it? Beats the heck out of me. I just spent five
minutes examining an old lens with its captured screws and can't figure
it out at all. It just makes no sense?
PFM....
Mike
_______________________________________________
Detomaso Forum Managed by POCA
Posted emails must not exceed 1.5 Megabytes
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso_poca.com
To manage your subscription (change email address, unsubscribe, etc.)
use the links above.
.
More information about the DeTomaso
mailing list