[DeTomaso] Rollover valve installation
Rob Dumoulin
rob at dumoulins.net
Sun Aug 30 12:28:08 EDT 2015
Darned spell check. I really hate sending emails from a phone. Correction
made below.
On Aug 30, 2015 11:52 AM, "Rob Dumoulin" <rob at dumoulins.net> wrote:
>
> I purchased a Hall anti rollover valve for #1488. I have an early tank
still wrapped in fiberglass. The existing vent assembly is riveted in 4
spots. The Hall unit has 3 holes.
>
> What is the best way to remove rivets without dropping them in the tank.
Do I need a gasket when I install the Hall unit? Simple self-tapping sheet
metal screws?
-------------- next part --------------
Darned spell check.A I really hate sending emails from a phone.
Correction made below.
On Aug 30, 2015 11:52 AM, "Rob Dumoulin" <[1]rob at dumoulins.net> wrote:
>
> I purchased a Hall anti rollover valve for #1488. I have an early
tank still wrapped in fiberglass. The existing vent assembly is riveted
in 4 spots. The Hall unit has 3 holes.
>
> What is the best way to remove rivetsA without dropping them in the
tank. Do I need a gasket when I install the Hall unit?A Simple
self-tapping sheet metal screws?
References
1. mailto:rob at dumoulins.net
More information about the DeTomaso
mailing list