[DeTomaso] Body measurements

[Mike Drew]

Michael,

The measurements are published in the last TSB I believe. Don't have them handy at the moment to confirm. 

I also have an extremely detailed body drawing that was used to manufacture the stamping tools for the body. It's probably well outside the realm of most body shops to understand it, but if you were going to fabricate fenders etc from scratch it might be helpful. Let me know if you want me to send it to you. 

Mike

Sent from my iPhone

On Aug 20, 2015, at 16:26, Michael Shortt <michaelsavga at gmail.com> wrote:

>  Does anybody have the body measurements for the car?
>  I need the length of the area between the wheels ( rear section of
>  front fender, door bottom, front area of rear fender and the height
>  from the bottom of the door up to the crease, (above the rocker)
>  Thanks,
>  Michael
>  --
>  Michael L. Shortt
>  Savannah, Georgia
>  [1]www.michaelshortt.com
>  [2]michael at michaelshortt.com
>  912-232-9390
>  A
>  This email is protected by the Electronic Communications Privacy
>  Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
>  privileged.A  If you are not the intended recipient, you are hereby
>  notified
>  that any retention, dissemination, distribution or copying of this
>  communication is strictly prohibited.A  Please reply to the sender that
>  you
>  have received this message in error, then delete it.A  Thank you
> 
> References
> 
>  1. http://www.michaelshortt.com/
>  2. mailto:michael at michaelshortt.com
> _______________________________________________
> 
> Detomaso Forum Managed by POCA
> Posted emails must not exceed 1.5 Megabytes
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com
> 
> To manage your subscription (change email address, unsubscribe, etc.) use the links above.