[DeTomaso] ZF polish question.
michael at michaelshortt.com
michael at michaelshortt.com
Thu Sep 11 20:31:03 EDT 2014
I have read that the polish process makes the ZF run hotter because the
pores of the cases are closed off, mine is simplimy super duper cleaned by
using Eagle One wheel cleaner that etches, not ordinary wheel cleaner,
followed by Aluminum jelly. If I were going to jazz it up, i love the look
of the black wrinkle finkle with the tops of the ribs in raw silver.
Michael Shortt
On Thu, Sep 11, 2014 at 8:21 PM, Boyd Casey <boyd411 at gmail.com> wrote:
> I have my motor out of the car and the ZF separated from the engine. Is
> it possible to polish the ZF without doing harm to the trans axle if
> you polish it while it is still assembled? What other finish or clean
> up techniques can anyone recommend ?
> Thanks,
> Boyd
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com
>
>
--
Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com
912-232-9390
This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged. If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited. Please reply to the sender that you
have received this message in error, then delete it. Thank you
-------------- next part --------------
I have read that the polish process makes the ZF run hotter because the
pores of the cases are closed off, mine is simplimy super duper cleaned
by using Eagle One wheel cleaner that etches, not ordinary wheel
cleaner, followed by Aluminum jelly. If I were going to jazz it up, i
love the look of the black wrinkle finkle with the tops of the ribs in
raw silver.
Michael Shortt
On Thu, Sep 11, 2014 at 8:21 PM, Boyd Casey <[1]boyd411 at gmail.com>
wrote:
A A I have my motor out of the car and the ZF separated from the
engine. Is
A A it possible to polish the ZF without doing harm to the trans
axle if
A A you polish it while it is still assembled? What other finish or
clean
A A up techniques can anyone recommend ?
A A Thanks,
A A Boyd
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
[2]DeTomaso at poca.com
[3]http://poca.com/mailman/listinfo/detomaso_poca.com
--
Michael L. Shortt
Savannah, Georgia
[4]www.michaelshortt.com
[5]michael at michaelshortt.com
912-232-9390
A
This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged.A If you are not the intended recipient, you are hereby
notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited.A Please reply to the sender that
you
have received this message in error, then delete it.A Thank you
References
1. mailto:boyd411 at gmail.com
2. mailto:DeTomaso at poca.com
3. http://poca.com/mailman/listinfo/detomaso_poca.com
4. http://www.michaelshortt.com/
5. mailto:michael at michaelshortt.com
More information about the DeTomaso
mailing list