[DeTomaso] Rolling Rear Fender Lips

[Mike Thomas]

Thanks.  The fronts are already rolled, just not the rears.
Mike

-----Original Message-----
From: Mark Charlton [mailto:pantera01826 at rogers.com] 
Sent: Thursday, September 04, 2014 7:22 PM
To: detomaso mail list; Mike Thomas
Subject: Re: [DeTomaso] Rolling Rear Fender Lips

When I did mine I considered fancy tools and ended up using a very simple
but effective method.

I heated the fender lip paint so it was very warm to the touch (and kept
re-heating as I worked along it so the paint wouldn't crack). I then
gradually hammered the fender lips inwards using a small lead hammer with a
few layers of heavy soft rag covering the head (to protect the paint).
Gentle taps working along the fender back and forth several times was all
that was needed to roll the lips inward very nicely. No cracked paint, no
body damage and not risk of catching the tires on the lips. And no special
tools.

I assume you will also be lowering the fronts, and that area MUST be rolled
so the tires don't catch - especially if you're running wider than stock
from tires.

Mark Charlton
pantera01826 at rogers.com



On Sep 4, 2014, at 10:08 PM, Dave Londry <davel at emspace.com> wrote:

> Drop $209 on one of these?
> http://www.tirerack.com/accessories/detail.jsp?ID=52
> 
> Rent one from Eastwood $40?
> http://www.ebay.com/itm/RENTAL-Fender-Roller-Lip-Forming-Rolling-Tool-
> Eastwood-RENT-Return-Label-Include-/161400710944?pt=Automotive_Service
> s&hash=item25943b6720
> 
> dave
> 
> On 04/09/2014 6:56 PM, Mike Thomas wrote:
>> I've finally picked up a set of adjustable upper rear A arms so I can 
>> drop the car a little further and keep the camber correct at the 
>> rear.  I suspect I'll get some interference with the inner lip of the 
>> rear fender if I don't roll it.  I recall a thread many years ago on 
>> various ways to do this yourself without damaging the outer fender.  
>> I have a piece of broom handle that I was going to start working back 
>> and forth while tapping with a hammer, wheel off of course.
>> 
>> One method I recall was to run such as a broom handle between the 
>> tire and fender and use the tire as leverage.  I won't be dropping it 
>> enough for that as the tire won't be quite that close to the fender.  
>> I suppose another way would be to install the new A arms, adjust them 
>> as close to zero-c as I can at the desired ride height, then lift the 
>> car, remove the coil-over, and swing the suspension to see if I still
have clearance.
>> 
>> Other ideas?
>> 
>> Thanks
>> Mike Thomas
>> VP, POCA
>> VP, Panteras Northwest
>> Yellow '74 #6328
>> 
>> 
>> 
>> 
>> _______________________________________________
>> 
>> Detomaso Forum Managed by POCA
>> 
>> DeTomaso mailing list
>> DeTomaso at poca.com
>> http://poca.com/mailman/listinfo/detomaso_poca.com
>> 
>> 
> 
> 
> _______________________________________________
> 
> Detomaso Forum Managed by POCA
> 
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com