[DeTomaso] Lower bellhousing to ZF bolts/studs ?????
B Hower
b.hower3400 at yahoo.com
Mon Oct 27 11:09:20 EDT 2014
I believe those were OEM 10x40 bolts not studs. Mine had none when I had my ZF out the first time. I believe I ordered 2 in March of 2010 from Dennis @ 1.65 each.
Three nuts may hold a wheel on the car,.........but I prefer to use 5 as designed. JMHO Bud #3400 ( Drive it like there is no tomorrow -- for there may not be ! )
From: doug351c <doug351c at gmail.com>
To: POCA Forum Mailing List <detomaso at poca.com>
Sent: Monday, October 27, 2014 12:40 AM
Subject: [DeTomaso] Lower bellhousing to ZF bolts/studs ?????
I'm looking at my ZF and I'm seeing two M10x1.5 studs, nuts and washers
securing my two lower ZF to Bellhousing holes. I'm hoping this forum can
refresh my memory because the nuts are 17mm hex nuts that were custom ground
down to a 6mm thin-pattern thickness (by yours truly) to provide maximum
clearance for my 10.5" Centerforce clutch. There are no withness marks on
the clutch housing so obviously these fasteners are not getting in the way.
Is my memory correct that DeTomaso never installed fasteners in these holes?
I belive I added them years ago for added strength. What have others seen
in their bellhousings?
Doug Braun
blue 73L #5505
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso_poca.com
-------------- next part --------------
I believe those were OEM 10x40 bolts not studs. Mine had none when I
had my ZF out the first time. I believe I ordered 2 in March of 2010
from Dennis @ 1.65 each.
Three nuts may hold a wheel on the car,.........but I prefer to use 5
as designed. JMHO
Bud #3400 ( Drive it like there is no tomorrow -- for there may not be
! )
__________________________________________________________________
From: doug351c <doug351c at gmail.com>
To: POCA Forum Mailing List <detomaso at poca.com>
Sent: Monday, October 27, 2014 12:40 AM
Subject: [DeTomaso] Lower bellhousing to ZF bolts/studs ?????
I'm looking at my ZF and I'm seeing two M10x1.5 studs, nuts and washers
securing my two lower ZF to Bellhousing holes. I'm hoping this forum
can
refresh my memory because the nuts are 17mm hex nuts that were custom
ground
down to a 6mm thin-pattern thickness (by yours truly) to provide
maximum
clearance for my 10.5" Centerforce clutch. There are no withness marks
on
the clutch housing so obviously these fasteners are not getting in the
way.
Is my memory correct that DeTomaso never installed fasteners in these
holes?
I belive I added them years ago for added strength. What have others
seen
in their bellhousings?
Doug Braun
blue 73L #5505
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
[1]DeTomaso at poca.com
[2]http://poca.com/mailman/listinfo/detomaso_poca.com
References
1. mailto:DeTomaso at poca.com
2. http://poca.com/mailman/listinfo/detomaso_poca.com
More information about the DeTomaso
mailing list