[DeTomaso] Tach adapter with ready-to-run MSD distributor?
MikeLDrew at aol.com
MikeLDrew at aol.com
Fri Mar 21 17:24:06 EDT 2014
In a message dated 3/21/14 13 25 9, thomas at hax.se writes:
> The tach has a resistor in series with the input and if the amplitude of
> the signal is too weak it may work to bypass that resistor. That's how I
> got the tach to work with EDIS, with the signal (12V) that is normally used
> for the tach.
>
> It requires opening the tach though.
>
>
>>>Lots of people have installed this ready-to-run setup with no problems
in their Panteras--waiting for one of them to explain how they did it. I
have one in my GT350 clone, and the tach wire worked the aftermarket tach just
fine?
So I'm confused....
Mike
-------------- next part --------------
In a message dated 3/21/14 13 25 9, thomas at hax.se writes:
The tach has a resistor in series with the input and if the
amplitude of the signal is too weak it may work to bypass that
resistor. That's how I got the tach to work with EDIS, with the
signal (12V) that is normally used for the tach.
It requires opening the tach though.
>>>Lots of people have installed this ready-to-run setup with no
problems in their Panteras--waiting for one of them to explain how they
did it. I have one in my GT350 clone, and the tach wire worked the
aftermarket tach just fine?
So I'm confused....
Mike
More information about the DeTomaso
mailing list