[DeTomaso] Clutch Master Access Hole - Recommendations?
shawkins777 at comcast.net
shawkins777 at comcast.net
Tue Jul 22 17:45:40 EDT 2014
What are you going to adjust on the clutch master?
Steve
----- Original Message -----
From: "forum, Pantera" <detomaso at poca.com>
To: "forum, Pantera" <detomaso at poca.com>
Sent: Tuesday, July 22, 2014 4:37:01 PM
Subject: [DeTomaso] Clutch Master Access Hole - Recommendations?
I need to do an adjustment to my clutch master, and am going to bite the bullet and cut the access hole in the side. I've seen one where 3 sides of the access hole are cut, then bent out of the way for adjustments, then bent back when done. I've seen one where all 4 sides are cut and the metal removed and just the carpet covers the open hole.
What I'd like to ask is, what other options are there? This is a pretty creative group, and I'm sure someone has made a very cool modification for this. riveted on a hinge and put a latch? Maybe added an actuator and put it on the garage door remote?
Seriously, what are some good ideas to make this as clean of an access hole as possible? I was thinking maybe to cut all 4 sides, then use a piece of sheet magnet to cover (under the carpet of course). appreciate any ideas you have!
brent
4328
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso_poca.com
-------------- next part --------------
What are you going to adjust on the clutch master?
Steve
__________________________________________________________________
From: "forum, Pantera" <detomaso at poca.com>
To: "forum, Pantera" <detomaso at poca.com>
Sent: Tuesday, July 22, 2014 4:37:01 PM
Subject: [DeTomaso] Clutch Master Access Hole - Recommendations?
I need to do an adjustment to my clutch master, and am going to bite
the bullet and cut the access hole in the side. I've seen one where 3
sides of the access hole are cut, then bent out of the way for
adjustments, then bent back when done. I've seen one where all 4 sides
are cut and the metal removed and just the carpet covers the open
hole.
What I'd like to ask is, what other options are there? This is a
pretty creative group, and I'm sure someone has made a very cool
modification for this. riveted on a hinge and put a latch? Maybe
added an actuator and put it on the garage door remote?
Seriously, what are some good ideas to make this as clean of an access
hole as possible? I was thinking maybe to cut all 4 sides, then use a
piece of sheet magnet to cover (under the carpet of course).
appreciate any ideas you have!
brent
4328
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso_poca.com
More information about the DeTomaso
mailing list