[DeTomaso] Condenser fitting
Forest Goodhart
forestg at att.net
Fri Jul 11 17:22:43 EDT 2014
I don't think the shoulder is a problem. It is there to seat the o-ring. It appears from your initial photo that the o-ring adapter was never seated properly into the condenser fitting. You should not be able to see the o-ring. The shoulder may be keeping the AN flare from seating on the 45* flare however. If it were me I would have the flare fitting on the hose changed to an o-ring fitting and be done with it.
Good luck,
Forest
________________________________
From: Tom Shinrock via DeTomaso <detomaso at poca.com>
To: detomaso at poca.com
Sent: Friday, July 11, 2014 2:13 PM
Subject: [DeTomaso] Condenser fitting
Sometimes I amaze myself how stupid I can be.
I received a lot of good advise suggesting that I had a flare adapter
in an o-ring fitting on my condenser. I was convinced enough to go try
and pull the adapter out of the fitting.
Well, when I pulled back the threaded barrel that screws into the
female flare fitting guess what I saw. It is a straight flare. I'm
now guessing (as Larry Finch suggested) that the shoulder on the flare
was created when the AN fitting was tightened down on it.
So now I'm trying to figure out my next move beyond replacing the AN
connector. Can the flare be reworked to remove the shoulder?
Tom
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso_poca.com
-------------- next part --------------
I don't think the shoulder is a problem. It is there to seat the
o-ring. It appears from your initial photo that the o-ring adapter was
never seated properly into the condenser fitting. You should not be
able to see the o-ring. The shoulder may be keeping the AN flare from
seating on the 45* flare however. If it were me I would have the flare
fitting on the hose changed to an o-ring fitting and be done with it.
Good luck,
Forest
From: Tom Shinrock via DeTomaso <detomaso at poca.com>
To: detomaso at poca.com
Sent: Friday, July 11, 2014 2:13 PM
Subject: [DeTomaso] Condenser fitting
Sometimes I amaze myself how stupid I can be.
I received a lot of good advise suggesting that I had a flare adapter
in an o-ring fitting on my condenser. I was convinced enough to go
try
and pull the adapter out of the fitting.
Well, when I pulled back the threaded barrel that screws into the
female flare fitting guess what I saw. It is a straight flare. I'm
now guessing (as Larry Finch suggested) that the shoulder on the
flare
was created when the AN fitting was tightened down on it.
So now I'm trying to figure out my next move beyond replacing the AN
connector. Can the flare be reworked to remove the shoulder?
Tom
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
[1]DeTomaso at poca.com
[2]http://poca.com/mailman/listinfo/detomaso_poca.com
References
1. mailto:DeTomaso at poca.com
2. http://poca.com/mailman/listinfo/detomaso_poca.com
More information about the DeTomaso
mailing list