[DeTomaso] Cooling System

[Asa Jay Laughton]

>From my notes, this illustration is a copy of the factory one, courtesy
John Taphorn:

Asa Jay Laughton, MSgt, USAFR, Retired
& Shelley Marie
Spokane, WA
******************************     
http://www.racingagainstautism.com
http://www.teampanteraracing.com
http://facebook.com/racingagainstautism


On 7/7/2014 11:57 AM, Mike Drew via DeTomaso wrote:
> The diagram is in the shop manual and may also be in the owner's manual, I can't remember. 
>
> When in doubt, RTFM! :)
>
> Mike
>
> Sent from my iPhone
>
> On Jul 7, 2014, at 20:13, "Stephen Nelson" <steve at snclocks.com> wrote:
>
>> Whilst I have spent some time looking around on the internet I haven't
>> managed to find a good diagram of the cooling system, including the heater
>> system.  Is there a good diagram out there?  
>>
>> And, while on the subject of cooling, do folks typically use straight
>> outlets from aftermarket (edelbrock) aluminum water pumps for the heater
>> pipes or are pipes that angle at 45 or 90 degrees preferred.  
>>
>> I noted that the temperature sender was located at the front of 5332's
>> block, rather than on the swirl tank.  But, that hole looks to be a good fit
>> for the MSD fuel injection temperature sensor.  Is there an inherent problem
>> with having the temperature sender on the swirl tank?  Or is there a better
>> place to put the temperature gauges sender?
>>
>> Stephen Nelson
>>
>>
>>
>> _______________________________________________
>>
>> Detomaso Forum Managed by POCA
>>
>> DeTomaso mailing list
>> DeTomaso at poca.com
>> http://poca.com/mailman/listinfo/detomaso_poca.com
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1432 / Virus Database: 3955/7309 - Release Date: 07/07/14
>
>