[DeTomaso] Cooling System

[Paul Timko]

You want the temperature sender in the block.

Paul
#9270

On 7/7/2014 1:13 PM, Stephen Nelson wrote:
> Whilst I have spent some time looking around on the internet I haven't
> managed to find a good diagram of the cooling system, including the heater
> system.  Is there a good diagram out there?
>
> And, while on the subject of cooling, do folks typically use straight
> outlets from aftermarket (edelbrock) aluminum water pumps for the heater
> pipes or are pipes that angle at 45 or 90 degrees preferred.
>
> I noted that the temperature sender was located at the front of 5332's
> block, rather than on the swirl tank.  But, that hole looks to be a good fit
> for the MSD fuel injection temperature sensor.  Is there an inherent problem
> with having the temperature sender on the swirl tank?  Or is there a better
> place to put the temperature gauges sender?
>
> Stephen Nelson
>
>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com
>