[DeTomaso] Instructions for reaching headlight motor and gear
MikeLDrew at aol.com
MikeLDrew at aol.com
Sat Aug 30 13:38:40 EDT 2014
In a message dated 8/30/14 9 04 49, will.kooiman at gmail.com writes:
> There is a sheet metal plate that holds the motor, and I believe the
> limit
> switches too. There should be 3 bolts holding it in, plus you have to
> disconnect the wiring, of course. If you remove those bolts, the whole
> thing comes out. It isn〓t too difficult.
>
>>>Don't forget that one of the switches must be removed from the sheet
metal mounting plate, to get it past the headlight bar.
Charlie's car is a GT5-S which is different in several regards here. His
car doesn't have the manual raising mechanism so it's just a guess that the
other aspects of the procedure are the same....
Mike
-------------- next part --------------
(J
(B (JIn a message dated 8/30/14 9 04 49, will.kooiman at gmail.com writes:
(B (J
(B (J
(B (J
There is a sheet metal plate that holds the motor, and I believe the
limit
(B (Jswitches too. There should be 3 bolts holding it in, plus you
have to
(B (Jdisconnect the wiring, of course. If you remove those bolts,
the whole
(B (Jthing comes out. It isn$B".(Jt too difficult.
(B (J
(B (J
(B (J>>>Don't forget that one of the switches must be removed from the
sheet metal mounting plate, to get it past the headlight bar.
(B (J
(B (JCharlie's car is a GT5-S which is different in several regards
here. His car doesn't have the manual raising mechanism so it's just a
guess that the other aspects of the procedure are the same....
(B (J
(B (JMike(B
More information about the DeTomaso
mailing list