[DeTomaso] 17-inch wheel back spacing
taappleby at bigpond.com
taappleby at bigpond.com
Wed Aug 13 02:29:07 EDT 2014
Off the subject a little bit - could we add a spacer to the rear 8" wheel,
to fill the wheel well (track) and sit like a 10" wheel?
if so what size spacer? (I suppose it would have to be center centric 62mm).
Terry.
-----Original Message-----
From: Mike Drew via DeTomaso
Sent: Wednesday, August 13, 2014 2:07 PM
To: doug351c at gmail.com ; MikeLDrew at aol.com
Cc: detomaso at poca.com
Subject: Re: [DeTomaso] 17-inch wheel back spacing
In a message dated 8/11/14 18 58 11, doug351c at gmail.com writes:
> At the rear, if you put 1/2 the additional 1" wider wheel width on each
> side
> of the wheel, all you'll get is a wider tire section width near the rim
> with
> the same section width at the crown of the tread.
>
>>>You would also get tire/wheel crashing into the fender!!!
You can't add any extra width to the outside, relative to a 15x10 wheel.
All additional width needs to go to the inside, moving the center of the
contact patch inward somewhat (since you would also be running a wider
tire).
So far only Julian has provided an *actual* answer, rather than a
theoretical/guestimate one. Can anybody else offer up *actual* backspace
measurements from 17x8 and 17x11 wheels?
THANKS!
Mike
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso_poca.com
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4744 / Virus Database: 4007/8025 - Release Date: 08/12/14
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4744 / Virus Database: 4007/8025 - Release Date: 08/12/14
More information about the DeTomaso
mailing list