[DeTomaso] 17-inch wheel back spacing
MikeLDrew at aol.com
MikeLDrew at aol.com
Wed Aug 13 00:07:56 EDT 2014
In a message dated 8/11/14 18 58 11, doug351c at gmail.com writes:
> At the rear, if you put 1/2 the additional 1" wider wheel width on each
> side
> of the wheel, all you'll get is a wider tire section width near the rim
> with
> the same section width at the crown of the tread.
>
>>>You would also get tire/wheel crashing into the fender!!!
You can't add any extra width to the outside, relative to a 15x10 wheel.
All additional width needs to go to the inside, moving the center of the
contact patch inward somewhat (since you would also be running a wider tire).
So far only Julian has provided an *actual* answer, rather than a
theoretical/guestimate one. Can anybody else offer up *actual* backspace
measurements from 17x8 and 17x11 wheels?
THANKS!
Mike
-------------- next part --------------
In a message dated 8/11/14 18 58 11, doug351c at gmail.com writes:
At the rear, if you put 1/2 the additional 1" wider wheel width on
each side
of the wheel, all you'll get is a wider tire section width near the
rim with
the same section width at the crown of the tread.
>>>You would also get tire/wheel crashing into the fender!!!
You can't add any extra width to the outside, relative to a 15x10
wheel. All additional width needs to go to the inside, moving the
center of the contact patch inward somewhat (since you would also be
running a wider tire).
So far only Julian has provided an *actual* answer, rather than a
theoretical/guestimate one. Can anybody else offer up *actual*
backspace measurements from 17x8 and 17x11 wheels?
THANKS!
Mike
More information about the DeTomaso
mailing list