[DeTomaso] VDO water temp sender

[Mikael]

Longchamp: This winter I'll rework the engine, get new transmission, and
rework rear end. Has started already. Some small parts need replacing while
engine is out.

 

I need a new temp sender to fit in the front of the Cleveland block, 3/8"
NPT I believe. Summit suggests this, has the VDO name in the description:

http://www.summitracing.com/dom/parts/vdo-323421/overview/

 

Does that mean I'll get correct reading on my 1978 30-70-110 C VDO gauge?
With the previous sender I think it showed too little, good cruising showed
at or just below 70 C. Might there be a resistor in the wiring I should
remove?

 

Mvh/Regards

Mikael

 

-------------- next part --------------
   Longchamp: This winter I'll rework the engine, get new transmission,
   and rework rear end. Has started already. Some small parts need
   replacing while engine is out.


   I need a new temp sender to fit in the front of the Cleveland block,
   3/8" NPT I believe. Summit suggests this, has the VDO name in the
   description:

   [1]http://www.summitracing.com/dom/parts/vdo-323421/overview/


   Does that mean I'll get correct reading on my 1978 30-70-110 C VDO
   gauge? With the previous sender I think it showed too little, good
   cruising showed at or just below 70 C. Might there be a resistor in the
   wiring I should remove?


   Mvh/Regards

   Mikael

References

   1. http://www.summitracing.com/dom/parts/vdo-323421/overview/