[DeTomaso] Throttle Cable Problem
Curt Hall
cuvee at sbcglobal.net
Wed Apr 16 19:11:49 EDT 2014
Well it seems the Throttle Cable needs to be replaced! Is there more then one length? My car is a 73. Do all the Vendors have them? It's been a while since I needed to buy anything. This has become a real pain! I'll try to get a photo.
Curt
________________________________
From: "MikeLDrew at aol.com" <MikeLDrew at aol.com>
To: cuvee at sbcglobal.net; detomaso at poca.com
Sent: Tuesday, April 8, 2014 5:06 PM
Subject: Re: [DeTomaso] Throttle Cable Problem
In a message dated 4/8/14 11 20 16, cuvee at sbcglobal.net writes:
I got a new throttle cable from one of the venders. It has the built in return spring at the end by the carb. The damn thing is so hard when pushing on the gas pedal I'm afraid the gas pedal is going to break! It don't seem to be binding anywhere! Has anyone else had this problem? Can the return spring be removed and use a aftermarket return spring? The original work really easy!
>
>>>It's almost assuredly NOT the spring that is the problem, but rather, the combination of many springs. You should have two external return springs. Assuming you do, the one in the throttle cable means you have THREE springs and that's one too many. Remove one of the two external springs.
Also, the spring tension on the throttle cable can be adjusted. If you have it compressed too much, you will make it too stiff.
Send me (or all of us) some photos of your current setup.
Mike
-------------- next part --------------
Well it seems the Throttle Cable needs to be replaced! Is there more
then one length? My car is a 73. Do all the Vendors have them? It's
been a while since I needed to buy anything. This has become a real
pain! I'll try to get a photo.
Curt
From: "MikeLDrew at aol.com" <MikeLDrew at aol.com>
To: cuvee at sbcglobal.net; detomaso at poca.com
Sent: Tuesday, April 8, 2014 5:06 PM
Subject: Re: [DeTomaso] Throttle Cable Problem
In a message dated 4/8/14 11 20 16, cuvee at sbcglobal.net writes:
I got a new throttle cable from one of the venders. It has the built
in return spring at the end by the carb. The damn thing is so
hard when pushing on the gas pedal I'm afraid the gas pedal is going
to break! It don't seem to be binding anywhere! Has anyone else had
this problem? Can the return spring be removed and use a aftermarket
return spring? The original work really easy!
>>>It's almost assuredly NOT the spring that is the problem, but
rather, the combination of many springs. You should have two external
return springs. Assuming you do, the one in the throttle cable means
you have THREE springs and that's one too many. Remove one of the two
external springs.
Also, the spring tension on the throttle cable can be adjusted. If you
have it compressed too much, you will make it too stiff.
Send me (or all of us) some photos of your current setup.
Mike
More information about the DeTomaso
mailing list