[DeTomaso] Clutch master and slave cylinder
Scott Bell
scott at saccrestorations.net
Tue Apr 15 15:11:09 EDT 2014
I never said to use a 7/8 inch master with a long throw slave. I would NOT do that.
What I said, (or meant), was you could use a 7/8 master with a stock slave to achieve a long throw installation.
Just another option...
-----Original Message-----
From: DeTomaso [mailto:detomaso-bounces at poca.com] On Behalf Of Larry Finch
Sent: Tuesday, April 15, 2014 11:31 AM
To: detomaso at poca.com
Subject: [DeTomaso] Clutch master and slave cylinder
Boyd,
I would call Dennis Quella and ask for his solution to your problem. (303) 660-6094. Tell Becky I sent you. :-)
My 2511 came from Dennis with a CNC 5/8" clutch master and an internal hydraulic throwout bearing.
At that time, the CNC bolt pattern required an aluminum adapter piece which Dennis supplied.
I would assume that adapter was sourced from Dennis' regular supplier - IPSCO, Mark Johnson (303) 252-4481
The Dennis sourced master was all aluminum, no SS or brass sleeve. I had rebuilt it once before, but with its obvious second failure
approaching, I looked for a better option than another rebuild.
I talked with Dennis and the very knowledgeable lady that picks up the phone at CNC.
I learned CNC now makes a proper bolt pattern clutch master for the Pantera. However, it is only sold through Dennis.
But as I already had the adapter, I could again use a new CNC master with their standard bolt pattern.
CNC offers most (all?) of their masters with a SS sleeve, but the SS is an upgrade option.
I ordered a standard (NOT Pantera bolt pattern) SS sleeved master, and on Dennis' advice changed to a bore of 3/4".
Part # 701-3/4-SS -- round CNC master with SS sleeve.
So, yes you can get a SS CNC clutch master. You can get a bolt-on from Dennis, just make sure it is the SS version.
Or you can source the adapter and use one of CNC's off-the-shelf SS versions.
As for Scott's suggestion of moving to a 7/8" version, I'd check with Dennis if that is advisable when used with your long-throw
slave.
Hope this helps.
Larry
More information about the DeTomaso
mailing list