[DeTomaso] Radiator Caps
michael@michaelshortt.com
michaelsavga at gmail.com
Wed Sep 18 11:28:20 EDT 2013
Every pound of pressure raises the boiling point of water 3 degrees. if
your system is designed for 10 psi and the cap is capable of holding that
you have increased the boiling point 30 degrees.
So a 16 psi cap could stand a temp of 260 degrees, whereas 22 psi could
handle up to 278 degrees.
I guess none of us want temps anywhere near 260 anyway, so perhaps the
lower rated cap is sufficient.
The next point then becomes, if the cap fails to release the pressure, then
something else might, like a hose, gasket, etc.
Michael
On Wed, Sep 18, 2013 at 11:20 AM, Larry Finch <fresnofinches at aol.com> wrote:
> Overflow is zero pressure cap.
>
> But why so high - 22PSI - on the surge tank cap?
>
> Larry
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
>
--
Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com
912-232-9390
This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged. If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited. Please reply to the sender that you
have received this message in error, then delete it. Thank you
More information about the DeTomaso
mailing list