[DeTomaso] Reverse switch issues
John Taphorn
jtaphorn at kingwoodcable.com
Wed Oct 16 00:13:22 EDT 2013
You can grind a nut thinner with your bench grinder. Double nut it
overhanging the end of a bolt and go for it.
JT
On 10/15/2013 10:21 PM, Corey Price wrote:
> I recently bought a reverse switch for my ZF. The ZF shift housing has a hole for the reverse switch to fit into, but it isn't threaded. The reverse switch has a threaded neck with one nut. I was told to find a thin M10 nut that can go on the inside and outside, but I have only 0.13" to work with between the inside of the housing and the shifter shaft.
>
> Suggestions? Steve Wilkinson suggested either a thin nut or welding up the hole re-drilling and tapping the new smaller hole for the M10 fine threads. I have a hunch that finding a thin enough nut is going to be a challenge. I've also considered filling with a metal-bearing epoxy and threading that.
>
> Corey
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com
>
More information about the DeTomaso
mailing list