[DeTomaso] Stock brake calibers & other musings

[eb0711 at kolumbus.fi]

Stock studs. Why do you ask?

-Janne

5/2/2013 1:20 AM, Asa Jay Laughton kirjoitti:
> Did you use the stock DeTomaso studs or something else?
>
> You might also remind folks where you got the rotors before they all 
> go out and try to buy the "bad" ones.
>
> Asa
>
> /Sent using Jedi mind tricks./
>
>
> -----Original message-----
>
>     *From: *MikeLDrew at aol.com*
>     To: *davel at emspace.com, eb0711 at kolumbus.fi*
>     Cc: *detomaso at poca.com*
>     Sent: *Wed, May 1, 2013 20:59:25 GMT+00:00*
>     Subject: *Re: [DeTomaso] Stock brake calibers & other musings
>
>
>     In a message dated 4/30/13 10 40 59, davel at emspace.com writes:
>
>
>     >
>     > Amen brother!
>     > When putting in the vented rotor upgrade I had to do the
>     left-front twice.
>     > I wired brushed the hat and did a careful job of pressing it
>     back together
>     > and still had 0.050 of runout.
>     > Second time it was with a wire wheel, until shiny, and had no
>     discernible
>     > runout.
>     >
>
>     >>>Lori and I (with me taking the photos) just finished this
>     project about
>     ten minutes ago. The 1965-67 Mustang front rotors fit great!
>
>     http://www.poca.com/index.php/gallery/?g2_itemId=39497
>
>     I know we did a better job on the second rotor, getting all the
>     mung off
>     the hub where it indexes on the center of the rotor. I hope we
>     don't have
>     runout on the first side we did?
>
>     Mike
>     _______________________________________________
>
>     Detomaso Forum Managed by POCA
>
>     DeTomaso mailing list
>     DeTomaso at poca.com
>     http://poca.com/mailman/listinfo/detomaso
>