[DeTomaso] "Dipsticks you can actually check" Final answer
SOBill at aol.com
SOBill at aol.com
Mon Mar 18 15:15:26 EDT 2013
Will do.
The main thing is to keep the main thing the main thing.
Do the best you can with what you have where you are.
Have fun today,
sobill at aol.com
In a message dated 3/18/2013 5:30:33 A.M. Pacific Daylight Time,
will.kooiman at gmail.com writes:
Look at the bright side.
A new dipstick is a lot cheaper than buying a 15 qt pan.
The measurements need to go into the Pantera_Information.xls database.
--
Will
On 3/18/13 7:58 AM, "Rob Dumoulin" <rob at dumoulins.net> wrote:
>First of all a big thank you to all that offered assistance, especially
>Garth and Chuck. The dipstick tube from the vendor had to be trimmed,
>bent,
>and coaxed, but installed once I removed my valve cover. The upper
>mounting
>bracket is not in the right place, but I'll fix that later.
>
>If I had to do it all again, I would have made my own and used the
>information from Garth and Chuck as reference. I question why I pay a
>premium for Pantera Parts from vendors that are not even close to being
>correct. If I were to install as received and was reassured by the vendor
>that it was correct, I estimate it would have taken 15 quarts of oil
>before
>it registered on the dipstick which was over 5 inches too short.
>
>If you buy from a vendor like I did, make sure they check their
>measurements. The only ones that matter if you are replacing both
>dipstick
>and tube are the distances with the dipstick fully installed in the tube
>from the flare that limits the tube depth into the block to the low and
>high marks on the dipstick. Make them measure before you buy and if they
>give you the answers they gave me, run away.
>
>Stock Dimensions:
>Length of tube below the ridge that bottoms out on the engine block:
>9-15/16"
>Length of tube, above ridge: 25"
>Total length of tube: 35"
>Tube diameter: 3/8"
>Full mark of dipstick: 11-9/16" below the ridge
>Add mark on dipstick: 12-3/8" below the ridge
>End of dipstick: 13-1/4" below the ridge
>Ford TSB calls for dipstick to be 38" - Measured from tip to the bottom of
>the handle 'cup'
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>DeTomaso mailing list
>DeTomaso at poca.com
>http://poca.com/mailman/listinfo/detomaso
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list