[DeTomaso] Stock Exhaust question

[Paul Timko]

I was pretty sure the gaskets I bought were conical on both sides, not 
just one.

Paul
#9270

On 6/13/2013 2:15 PM, Dave wrote:
> BIG BORE GASKETS:
>
> Big Bore exhaust to header.
>
> NAPA part number 31 381 about $9.00 ea.
>
> Gasket has about a ¼" steel ring (inside of the "donut") that extends out of one side of the donut. Works well.
>
>
> IndyDave
>
>
>
>
>
> -----Original Message-----
> From: MikeLDrew at aol.com [mailto:MikeLDrew at aol.com]
> Sent: Wednesday, June 12, 2013 5:41 PM
> To: JDeRyke at aol.com; rimovp at gmail.com; detomaso at poca.com
> Subject: Re: [DeTomaso] Stock Exhaust question
>
>
> In a message dated 6/12/13 13 56 50, JDeRyke at aol.com writes:
>
>
>> With donut gaskets, you really cannot
>> tighten the flanges tight- the thick donuts prevent it- so vibration &
>> heat tends to pound the fiberous donuts apart.
>>
>
>>>> Soft metal donuts are available which will resolve this
>>>> problem...just
> take your old donut down to NAPA/O'Reilly's/whatever and start wading through their stock.
>
> Cheers!
>
> Mike
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
>