[DeTomaso] NPC: recommendations for best tool for fuel line bending
michael@michaelshortt.com
michaelsavga at gmail.com
Tue Jun 4 13:53:26 EDT 2013
Most are pretty equal, start with a Harbor Freight unit and some junk fuel
line to practice.
If it doesn't work, return it and go spend the approx 3X more you will
elsewhere.
A great trick is to fill the tube with sand while you are bending it.
Michael Shortt
On Tue, Jun 4, 2013 at 1:18 PM, <cengles at cox.net> wrote:
>
> Dear Forum,
>
>
> I need to put some well controlled small bends in some
> 3/8" fuel line. What would you recommend for the best tube bender?
>
> Warmest regards, Chuck Engles
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
>
--
Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com
912-232-9390
This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged. If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited. Please reply to the sender that you
have received this message in error, then delete it. Thank you
More information about the DeTomaso
mailing list