[DeTomaso] Clutch Master Cylinder line thread size ?

[Scott Bell]

Don,

I have the fittings needed to connect a -3AN or a -4AN hose to the stock clutch master.

If you are using an aftermarket clutch master, I also have the fittings needed to convert the stock clutch master hardline from the
12mm x 1.0 Male Inverted Flare to a -3AN or -4AN fitting for connecting a -3 or -4 braided hose...

Scott
SACC Restorations
www.saccrestorations.net
951-461-2190

-----Original Message-----
From: detomaso-bounces at poca.com [mailto:detomaso-bounces at poca.com] On Behalf Of SOBill at aol.com
Sent: Saturday, July 06, 2013 3:44 PM
To: dtpantera at gmail.com; detomaso at poca.com
Subject: Re: [DeTomaso] Clutch Master Cylinder line thread size ?

Don,
 
My spare Bendix Italia clutch master cylinder has 12 x 1.0 threads  and 
requires a female 45 degree flare on the tubing fitting to seal against the  
male 45 degree flare fitting inside the master cylinder.
 
Is that description clear?
 
Finding a one piece adapter from the master cylinder to -3  AN will be a 
challenge (even for Google), so you might need to go the two  piece adapter 
route.
 
Let me know the source/part numbers for your  solution.
 
The main  thing is to keep the main thing the main thing.

Do the best you can with  what you have where you are.

Have fun today,

sobill at aol.com  

 
In a message dated 7/6/2013 1:56:53 P.M. Pacific Daylight Time,  
dtpantera at gmail.com writes:

What is  the thread size for the Clutch master Cylinder line ?
I need to get an  adaptor to convert the clutch line an AN-3 bib.
Any idea who might carry an  adaptor?
Thanks,
Don
_______________________________________________

Detomaso  Forum Managed by POCA

DeTomaso mailing  list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso


_______________________________________________

Detomaso Forum Managed by POCA

DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso