[DeTomaso] Electrical Issues AGAIN

Garth Rodericks garth_rodericks at yahoo.com
Tue Feb 19 12:30:42 EST 2013


Here's my Hazard Switch R&R page, but unfortunately I misplaced my wiring diagram before I had a chance to scan it for the website:
http://www.banzairunnerpantera.com/updates_hazardswitch.htm

Here's a thread on the PI Board with someone else's Hazard Switch wiring diagram (you must be logged in to see images):
http://pantera.infopop.cc/eve/forums/a/tpc/f/7890077274/m/5181048036

Here is the link to the wiring diagrams on Pantera Place; scroll down the page to "W":
http://www.panteraplace.com/page107.htm

Cheers!
Garth



--- Original Message ---

Garth's Banzaii Runner web site has wiring diagram for the switch. Jeff
6559 On Tue, Feb 19, 2013 at 8:52 AM, Kirby Schrader <kirby.schrader at gmail.com>wrote: >Richard, >>It certainly could be the flasher switch, but when I got my car back after >7 years of waiting, I had similar problems. >I initially suspected the switch, but everything magically worked after I >went around and cleaned up all the grounds. >>FWIW, >Kirby >>>On Tue, Feb 19, 2013 at 7:36 AM, Richard Greenblum <pantera at austin.rr.com >>wrote: >>> All, >> >> I'm the guy that got his car back from a restoration shop after 5 years. >> All they did was paint, not a complete restoration. >> >> When I took it in, everything except for the wipers worked.  When I got >it >> back, virtually nothing but one or two lightbulbs lit up.  Found the >> positive battery terminal slipped on, but no nut.  The negative was >upside >> down (small end to small end) and no bolt.  I can't believe it started >and >> ran fine.  Once I connected the battery properly, it all worked.
 >> >> Last week, the blinkers and horn stopped working.  Couldn't hear the >> relays, >> but as you know, it's pretty noisy with the engine running (full Euro GTS >> exhaust system).  Then, the water temp gauge, after climbing normally to >> around 190, would shoot to 240 then creep to 260, then off the scale. >> Engine was fine, not overheating at all.  Then, the lights in the gauges >> quit.  The lights in the wiper and hazard switches, and the green lights >in >> the bottom of the dash that shine down on the center section, work. >> >> Sunday, the horn started working, and without the engine running, I could >> hear the blinker relay going, but no blinker lights (the green indicator >or >> outside on the car).  So, I tried the hazard lights.  Same thing, could >> hear >> the relay, but no indicator or lights outside or in the .  Then, the >hazard >> switch would stay in for a couple of seconds, then pop out and I'd hear >the >> relay again, but no
 outside lights.  After about the fourth time I pushed >> the switch in, it stayed. >> >> I checked the ground under the dash where a few of them come together >above >> the driver's knee.  It was solid, or so it appeared.  A few years ago, I >> added a wire that runs from there to a steering column bolt, then from >> there >> to another bolt under the dash by the center section that I grounded the >> headlight relays to. >> >> I remember something about hazard switches causing a problem.  If I >> remember >> correctly, the hazard switch simply activates all of the blinkers at the >> same time, and those are what have failed.  Of course, the gauge lights >> don't work eitherŠ >> >> Got any ideas?  I've already hit SOBill with this hoping he'd have one of >> his usual epiphanies of brilliance. >> >> Richard >> Austin, TX >> #7080 >> >> >> >> >> _______________________________________________ >> >> Detomaso Forum Managed by POCA >> >> DeTomaso mailing
 list >> DeTomaso at poca.com >> http://poca.com/mailman/listinfo/detomaso >> >_______________________________________________ >>Detomaso Forum Managed by POCA >>DeTomaso mailing list >DeTomaso at poca.com >http://poca.com/mailman/listinfo/detomaso 


More information about the DeTomaso mailing list