[DeTomaso] bleeding clutch setup -cnc & pantera east setup
bill gaino
gaino at earthlink.net
Wed Feb 6 17:17:07 EST 2013
You may have air in the line. I know one solution was to tap on the line, while bleeding. Make sure the bleed at the slave is up.bench bleed the master. Keep trying. Bill 1362
-----Original Message-----
>From: Brian Hill <mazdastuff at yahoo.com>
>Sent: Feb 6, 2013 5:02 PM
>To: Detomaso List <detomaso at poca.com>, "SCPOCA at yahoogroups.com" <SCPOCA at yahoogroups.com>
>Subject: [DeTomaso] bleeding clutch setup -cnc & pantera east setup
>
>Hi all,
>reinstalled clutch slave after having ZF rebuilt. using CNC 3/4" master and Pantera East long throw slave. which on the vehicle and working beforehand the ZF overhaul. so typical, fix one thing and find more to fix.
>
> tried bleeding system with air powered vacuum on bleeder of slave and nothing is coming out.
>
>disconnected everything and cleared the pipe with no problem. Reconnected everything...holding fluid but I have zero pedal.
>Reservoir is full and stays at full level regardless of what I do...i.e. pump pedal or use vacuum.
>So I need some fresh thoughts about this. Why am I not getting fluid through the slave.
>
>Thanks
>Brian
>Fulshear,Texas
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>DeTomaso mailing list
>DeTomaso at poca.com
>http://poca.com/mailman/listinfo/detomaso
If you want it SLICK.. bring it to SLICKUM Paint Shop www.slickpaint.com
More information about the DeTomaso
mailing list