[DeTomaso] Clutch Slave Bolt Sizes
thomas
thomas at hax.se
Thu Aug 8 12:33:56 EDT 2013
There is one large bolt that goes through the bell housing and threads into the block, and that is a 7/16" bolt, longer than any standard 12pt ARP bolt. There are also two short M8 bolts that threads into the bell housing.
Thomas
8 aug 2013 kl. 18:14 skrev MikeLDrew at aol.com:
>
> In a message dated 8/8/13 1 49 48, garth_rodericks at yahoo.com writes:
>
>
>> What size bolts secure the clutch slave to the bell housing?
>>
>> There's the large bolt with the spacer that takes a 5/8" socket, but what
>> are the other two bolts?
>> I thought they were 5/16" but they don't seem to want to thread in.
>> Thought I'd better check with the list before wrenching them in tight and
>> buggering up the aluminum threads on the bell housing.
>>
>>
>
>>>> DOH! The bellhousing is European. European is metric. On the
> Pantera, if a bolt doesn't thread into an American thing, then it's metric.
>
> Interestingly, Wilkinson's website lists the bolt as being 7/16. But the
> Ford parts book correctly lists them as being M8 x 1.25 (metric fine).
>
> This begs the question--where are your old bolts?
>
> Mike
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
>
> !DSPAM:5203c40b20964274799312!
>
More information about the DeTomaso
mailing list