[DeTomaso] Carbon Fiber Pantera Hood

[gow2 at rc-tech.net]

Fitment is important if you don't plan on painting it and leaving the
carbon fiber look. Problem is these cars are hand built and fitment is
always touch and go. That was why I went with fiberglass which was a
really good decklid but still required a lot of work to get really good
fitment:

http://www.rc-tech.net/pantera1/decklid/dl.htm

My hood is aluminum and I can tell you fitment is tricky for these hoods;
especially around the front where it clears in opening:

http://www.rc-tech.net/pantera1/hood/hood.htm


http://www.rc-tech.net/cars2/panttransam/gal/may2013.jpg



>  I had the carbon fiber and fiberglass hood that others have mentioned.  I
> don't know where it came from but I felt that the fit wasn't as good as I
> wanted.  It also wasn't significantly lighter.
>
> Corey
>
>
> On Aug 6, 2013, at 10:36 AM, "michael at michaelshortt.com"
> <michaelsavga at gmail.com> wrote:
>
>> Who makes one?
>>
>> Arte they nice enough to remain unpainted?
>>
>> How much does one cost?
>>
>>
>> Thanks,
>>
>> Michael Shortt
>> --
>>
>>
>>
>>
>>
>>
>>
>> Michael L. Shortt
>> Savannah, Georgia
>> www.michaelshortt.com
>> michael at michaelshortt.com
>> 912-232-9390
>>
>>
>> This email is protected by the Electronic Communications Privacy
>> Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
>> privileged.  If you are not the intended recipient, you are hereby
>> notified
>> that any retention, dissemination, distribution or copying of this
>> communication is strictly prohibited.  Please reply to the sender that
>> you
>> have received this message in error, then delete it.  Thank you
>> _______________________________________________
>>
>> Detomaso Forum Managed by POCA
>>
>> DeTomaso mailing list
>> DeTomaso at poca.com
>> http://poca.com/mailman/listinfo/detomaso
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
>