[DeTomaso] Heat Insulation - Engine Bay
MikeLDrew at aol.com
MikeLDrew at aol.com
Sun Aug 4 12:53:37 EDT 2013
In a message dated 8/4/13 9 09 33, asajay at asajay.com writes:
> I'd like to put this stuff above the cooling tubes running under the
> car. Even with the heater hoses shut off in the engine compartment, the
> console got uncomfortably hot last week when I took it for a drive. The
> trouble is, all the original undercoating is still there and I don't
> know this stuff will stick to that very well.
>
>>>Just remove the interior console and wrap the center tunnel with heat
insulation, from above. I've done this and get ZERO heat into the cabin from
the cooling pipes.
Putting material above the cooling tubes, on the underside of the car,
would be an undertaking, plus it would trap moisture and rust the chassis from
the bottom up.
There are spray-on heat/noise barriers like Lizardskin which would be
extremely effective applied from underneath, however.
Mike
More information about the DeTomaso
mailing list