[DeTomaso] stock halfshaft u joint
B Hower
b.hower3400 at yahoo.com
Wed Apr 24 09:37:33 EDT 2013
You do want the clip to hold cup in place, without any chance of cup movement toward or away from the clip. This will ware an over-sized hole in the yoke. Ask me how I know.
Bud #3400 ( Drive it like there is no tomorrow -- for there may not be ! )
--- On Sun, 4/21/13, Justin Greisberg <justingreisberg at hotmail.com> wrote:
From: Justin Greisberg <justingreisberg at hotmail.com>
Subject: [DeTomaso] stock halfshaft u joint
To: "detomaso at poca.com" <detomaso at poca.com>
Date: Sunday, April 21, 2013, 7:57 PM
what fails when the shafts fail? What part actually breaks?
i installed new u joints from Pantera East in florida a few years back - they were a little long in one dimension but I mostly got the original clips to fit in place. However, one of the end caps was not too tight in one of the u joint "holders" on one end of one halfshaft - the press fit was not so tight anymore. no free play, just not too hard to slip in. all the other end caps were tight everywhere else, and required a vice/press to install. i dont think this would be likely to cause a failure - but asking?
justin
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list