[DeTomaso] stock halfshaft u joint
Mike Drew
MikeLDrew at aol.com
Sun Apr 21 21:33:30 EDT 2013
Justin,
Only the u joints fail. If your driveshafts are still good and you fit them with new I joints, you should be set for life!
Mike
Sent from my iPhone
On Apr 21, 2013, at 17:57, Justin Greisberg <justingreisberg at hotmail.com> wrote:
> what fails when the shafts fail? What part actually breaks?
> i installed new u joints from Pantera East in florida a few years back - they were a little long in one dimension but I mostly got the original clips to fit in place. However, one of the end caps was not too tight in one of the u joint "holders" on one end of one halfshaft - the press fit was not so tight anymore. no free play, just not too hard to slip in. all the other end caps were tight everywhere else, and required a vice/press to install. i dont think this would be likely to cause a failure - but asking?
> justin
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list