[DeTomaso] Repeat emails
Tom Shinrock
tmshinro at aol.com
Mon Apr 8 11:42:12 EDT 2013
Has anyone been receiving duplicate emails lately? I've gotten duplicates on several occasions within the last week, but not all the time.
However, this post from Julian today has set the new record. I got four copies.
Tom
5186
-----Original Message-----
From: Julian Kift <julian_kift at hotmail.com>
To: thomas <thomas at hax.se>
Cc: detomaso <detomaso at poca.com>; Asa Jay Laughton <asajay at asajay.com>
Sent: Mon, Apr 8, 2013 10:31 am
Subject: Re: [DeTomaso] Stock transmission speedo output
The speedos are identified as 1610 or 1210 revs/mile, as far as I'm aware the
angle drives (VDO at least) are only marked 1:1 or 1.1:1.
I went through this as an investigative process as my GT5 was way off in speedo
reading. I found it had the speedo face changed to mph (Euro import) but was off
until I changed angle drive.
Julian
> CC: asajay at asajay.com; detomaso at poca.com
> From: thomas at hax.se
> Subject: Re: [DeTomaso] Stock transmission speedo output
> Date: Mon, 8 Apr 2013 08:48:29 +0200
> To: julian_kift at hotmail.com
>
> There are two basic types of angle drives, VDO or Borletti. Early cars had VDO
and later cars Borletti.
>
> Each are available in two types, 1210 or 1610 revs per mile. The 1210 drives
are for kph speedos and the 1610 drives are for mph speedos.
>
> The VDO drives are marked 1210 or 1610, and the Borletti drives are marked 806
or 804.
>
> Thomas
>
> 8 apr 2013 kl. 01:52 skrev Julian Kift <julian_kift at hotmail.com>:
>
> > Speedo's are stamped on the rear either 1610 or 1210 rev/mile, which you
have will also depend on which angle drive your came with. Unfortunately I do
not know what goes with which year.
> > Is this what you wanted?
> > Julian
> >
> >> Date: Sun, 7 Apr 2013 12:28:11 -0700
> >> From: asajay at asajay.com
> >> To: detomaso at poca.com
> >> Subject: [DeTomaso] Stock transmission speedo output
> >>
> >> All,
> >> Assuming a stock 1973 ZF-2 and stock angle drive speedo adapter, what is
> >> the ratio of the speedo output to the axle output on a Pantera?
> >>
> >> i.e. the rear wheel goes around once and the speedo output goes around
> >> <how many times>
> >>
> >>
> >> Where can I find that information?
> >> Asa
> >>
> >> Asa Jay Laughton, MSgt, USAFR, Retired
> >> & Shelley Marie
> >> Spokane, WA
> >> ******************************
> >> http://www.racingagainstautism.com
> >> http://www.teampanteraracing.com
> >>
> >>
> >> _______________________________________________
> >>
> >> Detomaso Forum Managed by POCA
> >>
> >> DeTomaso mailing list
> >> DeTomaso at poca.com
> >> http://poca.com/mailman/listinfo/detomaso
> >
> > _______________________________________________
> >
> > Detomaso Forum Managed by POCA
> >
> > DeTomaso mailing list
> > DeTomaso at poca.com
> > http://poca.com/mailman/listinfo/detomaso
> >
> > !DSPAM:516206c713192322922530!
> >
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list