[DeTomaso] Inner front wheel bearing to sprindle fit?
Ken Green
kenn_green at yahoo.com
Wed Sep 26 14:54:40 EDT 2012
Will,
Which grit? fine?
Ken
________________________________
From: Will Kooiman <will.kooiman at gmail.com>
To: "MikeLDrew at aol.com" <MikeLDrew at aol.com>
Cc: "kenn_green at yahoo.com" <kenn_green at yahoo.com>; "detomaso at realbig.com" <detomaso at realbig.com>
Sent: Wednesday, September 26, 2012 9:30 AM
Subject: Re: [DeTomaso] Inner front wheel bearing to sprindle fit?
I cleaned it really well and then some light sanding with emery cloth. Like polishing shoes.
Sent from my iPhone
On Sep 26, 2012, at 12:01 PM, MikeLDrew at aol.com wrote:
>
> In a message dated 9/26/12 8 45 30, kenn_green at yahoo.com writes:
>
>
>> I tried to push one of the new wheel bearings onto the spindle, but it
>> won't slide into position. I don't want to force it because I'm not sure how
>> hard it would be to get it off, especially when it's under the seal in the
>> hub. Someone suggested polishing the spindle surface, any suggestions on
>> this, or how to polish it?
>
>>>> And Larry steps up to the plate....:>)
>
> Mike
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list