[DeTomaso] control arm bushings, thick shoulder in or out???
MikeLDrew at aol.com
MikeLDrew at aol.com
Tue Sep 18 19:47:09 EDT 2012
In a message dated 9/18/12 14 13 1, kenn_green at yahoo.com writes:
> I thought I had this figured out and the fatter shoulder was out on both
> bushings, and it fit that way in the rear. Now putting the front back
> together, the control arms fit with one fat shoulder out and one thin shoulder
> out, which is cool because I can install the bushings to slightly increase
> caster, but is that how it is suppose to be? The front control arm
> bushings would not slide into place with both fat shoulder out.
>
>>>Are these poly bushings?
Normally the stock A-arm bushings press in from the outsides....
Mike
More information about the DeTomaso
mailing list